1967 - 1969 Rear Axle Pinion Yoke Drive Shaft "U" Bolt Mounting Set

Home > Suspension >

Camaro Rear Axle Pinion Yoke Drive Shaft "U" Bolt Mounting Set

1967 - 1969 Rear Axle Pinion Yoke Drive Shaft "U" Bolt Mounting Set

Our Price: $9.95

PART NUMBER: TRA-779

Qty:

Description

Camaro Rear Axle Pinion Yoke Drive Shaft "U" Bolt Mounting Set

New correct design " U " bolt style mounts required to install your drive shaft U joint at the rear end axle. Because so many rear ends have been changed, rebuilt or altered, please make sure this is the version you need. The design goes through your non-threaded rear end yoke and you put a nut on the back side for mounting. From center to center measures about 1 and 3/8 inches. Includes; 2 U bolts, four nuts, and four lock washers.

* Fits non threaded yokes similar to pictured below with gap for U-bolt securing nuts:

Yoke is not included only pictured for reference.
** Please Note ~ This info is common but not always correct, again please double check your particular car. Over the years many cars have had a rear end swap.

67-69 10 bolt 8.2 rears normally used U bolt style = TRA-779
70-81 10 bolt 8.5 rears normally used strap style = TRA-778
67-68 12 bolt 8.75 rears normally used U bolt style = TRA-779
69-70 12 bolt 8.75 rears normally used strap style = TRA-778

PART NUMBER: TRA-779