1967 - 1968 Camaro Power Steering Crank Add On Driver Pulley, Big Block

1967 - 1968 Camaro Power Steering Crank Add On Driver Pulley, Big Block

New power steering crank driver pulley for your Camaro. Exact fit for all 67 and 68 models with a big block engine and a short length water pump. Original GM part number stamped 3874416 with "BP" code. Measures 6 and 3/4 inches in diameter and height is 2 inches. Factory correct for 396 with 325 or 350 horse engines.

NOTE ~ Please look at this pulley installed on the engine pictures. You can see how this pulley aligns. It sticks out a bit from the crank pulley for proper fitment.

NOTE ~ This Add On Power Steering Crank Driver pulley is for 1967 - 1968 engines with a SHORT LENGTH water pump. Over the years many cars have had an engine swap. Please double check your particular engine and make sure this will work for you.

NOTE ~ Shown installed with Single Grove Crank Pulley for your reference.

PART NUMBER: ENC-140

Please note this important warning ~ This is a stock replacement pulley. It is not designed to exceed 400 horsepower or 6000 rpms. Classic Headquarters assumes no liability for damage caused by improper usage.