Home > Lighting & Lenses > Backup Lights >

1967 - 1968 Camaro Reverse Backup Light Housing RH, Rally Sport
1967 - 1968 Camaro Reverse Backup Light Housing RH, Rally Sport


 
Our Price: $41.95

PART NUMBER: LIG-151
Qty:

Description
 
1967 - 1968 Camaro Reverse Backup Light Housing RH, Rally Sport

New back up light housing for your Camaro. Exact fit for all 67 - 68 Rally Sport models. This is for the right hand, passengers side reverse lamp housing. Includes wiring, rubber boot, grommet, connector and bulb. Proper 2 studs for mounting on the back side. Show chrome plating, order yours today!

PART NUMBER: LIG-151

Other Great Parts That You Might Need
1967 - 1968 Camaro Reverse Backup Light Housing LH, Rally Sport 1967 - 1968 Camaro Backup Light Lens Gaskets Set, Rally Sport, Die-Cut Gray Rubber, Pair 1967 - 1968 Camaro Reverse Backup Lights Kit, Rally Sport 1967 - 1968 Backup Light Lens, Rally Sport, Each
Our Price: $41.95

Add
Our Price: $6.95

Add
Our Price: $99.95

Add
Our Price: $7.95

Add
1967 - 1968 Camaro Reverse Backup Light Housing LH, Rally Sport 1967 - 1968 Camaro Backup Light Lens Gaskets Set, Rally Sport, Die-Cut Gray Rubber, Pair 1967 - 1968 Camaro Reverse Backup Lights Kit, Rally Sport 1967-1968 Rally Sport Backup Light Lens
1967 - 1968 Backup Light Housing Gaskets Set, Rally Sport, Black Rubber, Pair 1968 Camaro Rally Sport Tail Lights Kit 1967 - 1968 Camaro Backup Light Lens Gaskets Set, Rally Sport, Die-Cut Foam, Pair 1967 - 1968 Camaro Rear Body Tail Light Panel, Rally Sport
Our Price: $6.95

Add
Our Price: $335.95

Add
Sale Price: $4.50

Add
Our Price: $169.95

Add
1967-1968 Rally Sport Back Up Housing Seals 1968 Camaro Rally Sport Tail Lights Kit 1967 - 1968 Camaro Backup Light Lens Gaskets Set, Rally Sport, Die-Cut Foam, Pair 1967 - 1968 Camaro Rear Body Tail Light Panel, Rally Sport

Average Customer Review: Average Customer Review: 2 of 5 2 of 5 Total Reviews: 1 Write a review.

  0 of 0 people found the following review helpful:
 
2 of 5 Install studs too short. Light bulb well too big March 28, 2022
Reviewer: joe from USA  
The installation studs only protrude through the body panel holes 1/4 inch or so. Also the light would not sit flush against the body panel. I think that is because the light bulb well is slightly too big and hanging up on the circular hole it fits down into. Lens rattled because screws would not screw in enough. Attempted to remove and reinstall lens screws. Screws snapped off in housing. Sigh. I suppose if you don't mind buying longer  install studs, filing the housing down to fit, and drilling out lens screw holes and installing bolts and nuts instead the part is OK.

Was this review helpful to you?


Browse for more products in the same category as this item:

Lighting & Lenses > Backup Lights
1967 Camaro
1968 Camaro
Lighting & Lenses