Home > Custom Parts > Custom Exterior Parts > 1967 - 1969 Grille Insert Filler for Cowl Induction Hood, Fine Lines, Polished
	PART NUMBER: AIR-624 CURRENTLY UNAVAILABLE

Description   Getting tired of looking at that lopsided hole in the back side of your cowl hood? Here is a grille that cleans that area up and makes it more symmetrical looking. It'll keep those pesky birds and leaves ( and sometimes windshield wipers) out of your air cleaner. We know the cowl hoods were only available on the '69s, but since they fit all first gens, they have been installed on all 3 years. In case you are concerned about airflow, the total throttle plate area of a Holley 1050 is 9.6 sq.inches, the total open area of these grilles is 21sq.inches. More than adequate. These are made of 16ga aluminum so they will lay flat against the uneven surface around the opening. The factory did a so-so job of threading the mounting holes, so running a tap in them first is strongly suggested.  Fits 67 - 69 Camaro. Part Number: AIR-624 Average Customer Review: 4 of 5 Total Reviews: 2 Write a review.

0 of 0 people found the following review helpful:

Excellent July 1, 2014 Reviewer: rmf from fredericksburg, VA United States   Well made. Comes with good hardware. Fits perfectly. Follow advice and chase the threaded holes before inserting the screws. Was this review helpful to you?

0 of 0 people found the following review helpful:

Looks good May 29, 2014 Reviewer: Darrell Sego from Franklin, IN United States   The grille insert filler looks nice but it is made from very thin material.  Also hard to get on unless you remove the hood. Was this review helpful to you?

Browse for more products in the same category as this item: Custom Parts > Custom Exterior Parts Air Cleaner Components Air Cleaner Components > Cowl Induction Sheet Metal Model Years > 1967 Camaro Parts Model Years > 1968 Camaro Parts Model Years > 1969 Camaro Parts Custom Parts Engine Components Model Years